Recent Fab Lab Responses

• 5/20 @ 8:53 AM
  #5095: Matt Bernhardt
  The problem had been solved before I got down to check thing...
• 5/20 @ 8:52 AM
  #5118: Matt Bernhardt
  The lens has been cleaned. It is much better now, but will p...
• 5/7 @ 4:28 PM
  #5090: Matt Bernhardt
  Not sure either, but I'll keep an eye on it. Thanks.
• 5/5 @ 9:33 AM
  #5083: Matt Bernhardt
  The M-300 had been set to communicate via serial port - whic...
• 4/29 @ 1:13 PM
  #5071: Matt Bernhardt
  The origin of the laser cutter had been set incorrectly. Aft...
• 4/28 @ 9:14 AM
  #5069: Matt Bernhardt
  Troy got to it before I got down there.
• 4/22 @ 1:33 PM
  #5042: Matt Bernhardt
  The Y axis has been re-homed
• 4/18 @ 7:59 AM
  #5034: Matt Bernhardt
  The ShopBot was working normally this morning at 8 AM. I'm s...
• 4/16 @ 8:20 AM
  #5023: Matt Bernhardt
  The vector driver had lost its association with the USB port...
• 4/2 @ 8:13 AM
  #4974: Matt Bernhardt
  The driver has been reinstalled, and appears to now be worki...

Search Problem Reports