PART GALLERY

This page shows some previous jobs which were produced using the Stratasys, as well as some basic information about each job.

Project Information		Overall Size			Plastic Used
Image	Model Name	X	Y	Z	Build	Support	Total	Cost	Time
	Voronoi Model by Andrew Kudless	~10"	~3"	~3"	3.866	12.534	16.400	$73.80	30:59
	Furniture Model by Troy Malmstrom				2.993	0.898	3.891	$17.51	3:54
	Wall Mockup by Alexis Sliwinski				1.07	2.10	3.17	$14.27	12:35
	Digital Project Demonstration by Matt Bernhardt				3.895	3.749	7.644	$34.40	10:20

Recent Fab Lab Responses

8/14 @ 4:50 PM
#5259: Matt
Test passed.
8/14 @ 4:49 PM
#5260: Matt
Test passed
5/20 @ 8:53 AM
#5095: Matt Bernhardt
The problem had been solved before I got down to check thing...
5/20 @ 8:52 AM
#5118: Matt Bernhardt
The lens has been cleaned. It is much better now, but will p...
5/7 @ 4:28 PM
#5090: Matt Bernhardt
Not sure either, but I'll keep an eye on it. Thanks.
5/5 @ 9:33 AM
#5083: Matt Bernhardt
The M-300 had been set to communicate via serial port - whic...
4/29 @ 1:13 PM
#5071: Matt Bernhardt
The origin of the laser cutter had been set incorrectly. Aft...
4/28 @ 9:14 AM
#5069: Matt Bernhardt
Troy got to it before I got down there.
4/22 @ 1:33 PM
#5042: Matt Bernhardt
The Y axis has been re-homed
4/18 @ 7:59 AM
#5034: Matt Bernhardt
The ShopBot was working normally this morning at 8 AM. I'm s...